MAINTENANCE/SERVICE – M200 ENGINE
Form 169017 159 Issue – June 2008
m. Stop engine and drain water out before rust or
sediment settles. See steps d. to i.
n. Close radiator drain valve (B) and replace block
drain plug (D).
o. Fill system with a solution of clean water and a
heavy duty radiator cleaner. Follow instructions
provided with cleaner.
p. After using cleaner solution, again flush system
with clean water. See steps k. to m. Inspect
radiator, hoses and fittings for leaks.
q. Close radiator drain valve (B), and replace block
drain plug (D).
r. Fill system through radiator filler pipe (A) with an
equal part mix of anti-freeze and clean, soft
water. Use Ethylene Glycol or Propylene-Glycol
with SCA equal parts with water. System
capacity is 5.3 U.S. Gallons (20 litres).
s. Close radiator cap tightly.
t. Remove cap (E) from recovery tank (F) and add
coolant until half full.
u. Move maintenance platform to working position
and close engine compartment hood.
A
E
F
D
B
To Next Page
Loading...
