OPERATOR’S STATION
Form # 169017 40 Issue – June 2008
DISPLAY WARNINGS AND ALARMS (Continued)
DISPLAY
FLASHING
ALARM TONE DESCRIPTION
LOW HYDRAULIC OIL
Continuous Loud Tone For 5
Seconds. If Condition Not
Rectified, Single Loud Tone Every
5 Minutes
Low Hydraulic Oil Level. Header
Shuts Down Automatically If
Engaged. Header On Switch Must
Be Moved To OFF Position And
Then To ON Position To Restart The
Header.
NO HEADER
None
Header Is Not Detected.
NO OPERATOR
Continuous Tone.
Operator Not Detected In Seat With
Header Engaged Or Out Of Neutral
Detent.
NO OPERATOR
ENGINE SHUTDOWN
Continuous Tone.
Engine Shutdown When Operator
Not Detected In Seat With Machine
Moving Under 3 mph (4.8 km/h).
NOT IN PARK
Short Beep With Each Flash
GSL or Interlock Switches Not
Closed With Key On/Engine Off.
KNIFE OVERLOAD
Ongoing Intermittent Moderate
Tone Until Condition Is Corrected.
Machine Overload. Knife Or Disc
Speed Drops Below Programmed
Value.
PLACE GSL INTO “N”
Beeps At 2 Per Second Until
Corrected.
GSL or Interlock Switches Not
Closed With Key On/Engine Off.
TRANS OIL PRESS
Continuous Loud Tone Until Oil
Pressure Is Regained.
Low Transmission Charge Oil
Pressure.
TRANS OIL TEMP
Ongoing Intermittent Moderate
Tone Until Temperature Is Below
Acceptable Level.
Transmission Oil Temperature
Above 221F (100C).
##.# LOW VOLTS
Single Loud Tone For 10 Seconds. Voltage Below 11.5.
##.# HIGH VOLTS
Single Loud Tone For 10 Seconds. Voltage Above 16.
To Next Page
Loading...
