Security Chapter 10
Mastersizer 2000 Page 10-3
Setting up the Administrator
The first time the system is run just one user (named Administrator) and one
user group (named Administrators) are created automatically. The Administra-
tors group is originally set only to allow configuration of the security system and to
deny access to all other features of the system.
The first task is to set up the Administrator account.
To set up the administrator:
1. Select Security-Configure security to display this dialogue:
When the software is run for the first time, the security system defaults to a
member of the Administrators group with no password.
2. Select the Administrator name in the first row and then User-Properties.
Confirm the blank password for the Administrator account (that is, do not
type anything in) and click OK.
3. Click Options-Security settings... and in the Security Settings dialogue
shown below select the Enable security check box and click OK.
MAN0384-1.0 Mastersizer 2000.book Page 3 Tuesday, March 20, 2007 8:56 AM
To Next Page
Loading...
