Chapter 1 Introduction to this manual
Page 1-4 MAN 0384
Where to get help
Other manuals
Several manuals are supplied with the system, each giving information on a differ-
ent aspect of it. Below is a list of the typical manuals supplied with the system,
detailing the type of information in each one.
Quickstart Manual
This gives a simple introduction to the system and explains how to make a meas-
urement.
Essentials Manual
This manual covers:
Site requirements – all the physical requirements for positioning the system.
Information is given on service requirements (air, water, number of power
sockets, etc.), environmental requirements (temperature, humidity, etc.) and
physical requirements (space needed, etc.).
Note
The system must be initially commissioned by a Malvern-trained repre-
sentative.
Health and Safety – this must be read by all users of the system. It details all
safety issues for the optical bench and all dispersion units.
Maintenance – for both the optical bench and dispersion units.
Installation – this gives enough information to allow the user, for example, to
move the system from one laboratory to another. Instructions are also given on
how to install the Malvern software if the user upgrades the computer system.
Caution!
If the system is covered by a Qspec validation contract, we strongly recom-
mend that it is only moved by Malvern representatives.
Autosampler 2000 manual
The Autosampler 2000 has its own manual giving details on its use.
Dispersion Unit manuals
Each dispersion unit has its own manual giving details on its use.
MAN0384-1.0 Mastersizer 2000.book Page 4 Tuesday, March 20, 2007 8:56 AM
To Next Page
Loading...
