Making measurements - a tutorial Chapter 4
Mastersizer 2000 Page 4-19
All dispersion units are listed - even those that are not attached to the system. This
allows an SOP to be written remotely from the system.
Note
The versions of the following dialogues actually seen may differ slightly,
depending on the dispersion unit selected.
Material dialogue
This dialogue has two sections, Optical properties and Result calculation:
Optical properties
Use this section to define the optical properties of the material measured. The sys-
tem has a large database of commonly used materials, from which a Frequently
Used list may be created. The material and dispersant to be used in a measurement
are selected from the frequently used sample/dispersant list boxes. The Refractive
Index and Absorption of each item listed is displayed next to the list box.
Changes to the frequently used lists can be made by clicking on the Materials or
Dispersants buttons which open up the material/dispersant databases. This is also
the area where additional materials can be defined or existing ones modified.
i
MAN0384-1.0 Mastersizer 2000.book Page 19 Tuesday, March 20, 2007 8:56 AM
To Next Page
Loading...
