5
6
7
8
Removing and installing the oil cooler
63
Fig. 5
Remove oil cooler housing cover with fitted oil
cooler.
Figs. 6 and 7
Inspect the oil cooler for damage and replace if
necessary. Fit oil cooler with new seals.
Apply a thin bead of “Loctite 5900” sealing com-
pound to the seal À.
Fig. 8
Tighten the mounting bolts with the prescribed
torque.
D Screw on oil cooler housing cover with fitted oil
cooler
Initial torque: 50 Nm
Angle tightening 90_
D Attach oil filter head and oil filter with new seals
D Fit all pipes with new seals
D Fill coolant, see page 40
D Fill engine oil and check for leaks after a short
engine run
D Check the coolant and oil levels
1
To Next Page
Loading...
Need help?
General