Published 3-30-2018, CTRL 636-05 5-9
CD15 OPERATOR MANUAL ATTACHMENTS
SEARCHER HOOK ASSEMBLY
The searcher hook assembly mounts on the boom nose as
shown in Figure 5-6.
Installation
1. If not already done, assemble the hook (1) to the
searcher hook frame (6) with the pin (5) and the keeper
hardware provided.
2. Using a suitable lifting device, lift the searcher hook
assembly into position at the end of the boom nose and
align the mounting lugs on the frame (6) with the lugs on
the boom nose (9).
3. Install the connecting pins (7) and secure with them with
the hair-pin cotters (8).
Removal
Reverse the installation steps. Store the connecting pins (7)
and hair-pin cotters (8) in the mounting lugs on the frame (4).
CAUTION
Searcher hook maximum capacity: 2722 kg (6000 lb).
Do not exceed crane stability rating shown on load chart
in cab.
To Next Page
Loading...
Need help?
General
