SAFETY INFORMATION CD15 OPERATOR MANUAL
2-42 Published 3-30-2018, CTRL 636-05
NOTE: The following checklist includes all features that
can be found on Manitowoc cranes. Your crane
may not have some features.
Mast Inspection
Overload less than 25%
1a
Boom Sheaves,
Rope Guides
Inspect all for damage.
1b
Jib Sheave, Rope
Guides
Inspect all for damage.
2
Collar-Wear Pads,
Pad Retainers
Inspect for damage.
Overload from 25% to 49%
1
Sheaves, Rope
Guides
Inspect all for damage.
2
Collar-Wear Pads,
Pad Retainers
Inspect all for damage.
3 Collar-welds Inspect all for damage.
4 Jib Pinning Areas Inspect all for cracks.
5 Telescopic Sections
Inspect for bent or twisted sections. Check the boom
for straightness.
6
Lift Cylinder Head
Area
Inspect for bends or cracked welds.
7 Jib Section (far side)
Inspect for bent or twisted section. Check for
straightness.
8 Welds Inspect for cracks.
9 Paint
Inspect for cracked paint which could indicate twisted,
stretched, or compressed members.
To Next Page
Loading...
Need help?
General
