Information
1.3 Intended use
1 - 2 3 112 441 en Lattice extension operating instructions
GMK 4100/4100-L/5095
11.01.2008
1.3 Intended use
H
In addition to the following specifications, also observe the specifications
for intended use in the
Operating instructions GMK 4100/4100-L/5095.
The GMK 4100/4100-L/5095 may only be operated with parts of equipment
which have been approved by
Manitowoc Crane Group Germany GmbH and
are designated with the serial number of the truck crane.
1.4 Organisational measures
H
In addition to the following specifications, also observe the specifications
concerning organisational measures in the
Operating instructions and in the
Maintenance manual
of the crane delivered.
Make sure the maintenance personnel also have the expertise required to
operate the crane safely. Make sure the maintenance personnel have access
to the operating instructions.
Only trained or instructed personnel may carry out any work on the truck
crane.
The responsibilities regarding the operation of the crane and rigging, main-
tenance and repair work must be clearly defined.
Make sure those persons appointed to work on the truck crane are provided
with the information required for their work before beginning with work.
Instruct your personnel (e.g. banksmen, slingers, rigging personnel) accord-
ingly.
Observe all safety instructions and warnings on the truck crane.
Welding work on load-bearing parts may only be carried out by qualified
personnel with the manufacturer's prior permission. To avoid any damage,
especially to electronic components, you must take certain precautions
before performing any welding work. You should therefore always consult
CraneCARE before any welding work.
Spare parts must fulfil the technical requirements defined by the manufac-
turer. Genuine spare parts always meet these requirements.
To Next Page
Loading...
Need help?
General
