G7
80117010
1. LIFTING OF ENTIRE CRANE OR MAJOR CRANE ASSEMBLIES MUST BE ACCOMPLISHED BY
UTILIZING SPECIFIC FITTINGS INDICATED ON THE ABOVE CHART. USE OF FITTINGS FOR
PURPOSES OTHER THAN THOSE DESIGNATED ON THIS CHART IS PROHIBITED.
FITTING CAPACITIES ARE MAXIMUM ALLOWABLE LOADS PER INDIVIDUAL FITTING.
2. RIGGING PERSONNEL SHALL BE RESPONSIBLE FOR PROPER SELECTION AND PLACEMENT
OF ALL SLINGS AND LOAD HANDLING DEVICES.
3. DIMENSIONS AND WEIGHTS SHOWN ARE THE LARGEST CONFIGURATION AVAILABLE.
4. RIGGING PERSONNEL SHALL VERIFY DIMENSIONS AS REQUIRED FOR CLEARANCE.
5. EXTEND OUTRIGGER BEAMS 48 CM (18 IN) AND SLING AROUND BEAMS TO LIFT.
6. DO NOT USE PINTLE HOOKS OR CWT LUGS FOR LIFTING OR TYING DOWN THE ENTIRE CRANE.
7. REMOVE OUTRIGGERS AND COUNTERWEIGHT FOR TRANSPORT AS REQUIRED.
TRANSPORTATION AND LIFTING DATA GRT9165
TOTAL UNIT
D
E
1673cm
(659 in)
A
377 cm
(148 in)
87,223 kg
(192,292 lb)
676cm
(266 in)
16,206kg
(35,728 lb)
25,750kg
(56,770 lb)
3,955kg
(8,720 lb)
3,483kg
(7,680 lb)
A
D
E
B
C
C
B
F
H
G
H
G
J
F
REAR AXLE
L
C
168 cm
(66.3 in)
TIE DOWN
NO./UNIT
LIFT
TOW
TOW
TIE DOWN
FITTING CAPACITY (TONS)
TOW
TIE DOWN
LIFT
LIFT
LIFT
LIFT
LIFT
XX
XX
X
X
X
X
X
X
TOTAL
UNIT
CARRIER BOOM CWT O/R
BOX
FITTINGS
A
B
C
D
E
F
G
H
J
12
2
4
4
4
4
4
2
2
33
50
11
44
44
LIFT
SEE NOTE #5
BOOM
COUNTERWEIGHT
OUTRIGGER
BOX
X
X
X
X
(BOTH SIDES)
(BOTH SIDES)
LIFT BOOM USING APPROPRIATE
LIFTING DEVICE. DO NOT LIFT BY
PINNING HOLES.
(WITH BOOM EXTENSION STOWED)
To Next Page
Loading...
Need help?
General
