3-43 Masterflex REGLO Digital Pump Drive with Advanced Connectivity
Section 4: Service & Maintenance
Masterflex
FLUSHING THE PUMP HEAD
It is recommended that the pump head be ushed thoroughly after pumping in order to prevent the piston
from seizing due to remaining particles. Avoid pumping liquids containing abrasive solids.
CLEANING THE PUMP DRIVE
If required, the pump drive may be wiped clean using a soft cloth lightly moistened with either isopropyl or
ethyl alcohol.
NOTE:
• Do not use water, chlorine or any perfumed or aromatic cleaning agents on the pump drive.
• Care should be taken with the pump drive’s touchscreen to avoid scratching or otherwise damaging the
surface. Do not wipe with dry or abrasive material.
• Do not operate the pump drive with water on the surface of the touchscreen.
• Any damage caused by improper cleaning will be the sole responsibility of the customer.
ACCESSORIES
To purchase accessories or for further information visit www.masterex.com. e following accessories are
available for the REGLO Digital Pump Drive:
Description Part Number
Footswitch with 6 ft (1.8 m) cable and DB-25 male connector 07523-92
DB-25 male connector (no cable, connector only) 07523-94
Cable assembly (DB-25 male connector and 25 ft (7.9 m) cable with
stripped wire ends
07523-95
Dispensing Wand with 6 ft (1.8 m) cable and DB-25 male connector 07523-97
Power Supply 116065
Visit www.masterex.com for a full list of available ttings and accessories.
To Next Page
Loading...
