Masterflex ISMATEC 78018-50 - Safe Operation

1-1 Masterflex REGLO Digital Pump Drive with Advanced Connectivity
Section 1: Introduction
Masterflex
SECTION 1: INTRODUCTION
SAFE OPERATION
e REGLO Digital Pump Drive with Advanced Connectivity is designed for pumping and dispensing
applications in laboratory and process environments. Conrm that the pump drive is operated only in the
manner specied in this operating manual and that safe work practices and Good Laboratory Practice (GLP)
are followed. Misuse of the pump drive may compromise built-in safety protections and result in injury and/
or damage to equipment. Do not operate the pump drive with water on the surface of the touchscreen.
e following Safety Symbols are used in this documentation:
!
CAUTION: Risk of danger. Consult operating manual for nature of hazard and corrective actions.
CAUTION: Risk of crushing. Keep ngers away from the rotor while the pump is in operation.
Stop pump before loading or unloading tubing.
CAUTION: Hot Surface. Do not touch.
CAUTION: Risk of electric shock. Consult operating manual for nature of hazard and corrective
actions.
Please observe the following cautions and recommendations:
!
CAUTION: Do not operate the pump in a way that exceeds the designed operating and environ-
mental conditions outlined in this operating manual.
!
CAUTION: Do not exceed the specied maximum dierential pressure for the pump head.
!
CAUTION: e pump must not be used:
• As a medical device.
• In explosion proof chambers or in the presence of ammable gases or fumes.
CAUTION: e circuit between the mains power supply and the pump must be connected to
earth ground.
CAUTION: Do not handle the pump head before the pump is switched o and disconnected
from the mains power supply.
!
CAUTION: e pump must be switched o before removing the pump head.