Matrix SETU VFXTH System Manual

91 Matrix SETU VFXTH System Manual
• If you have G.723 as a Preferred Vocoder, select the G.723 Bit Rate as 5.3 Kbps or 6.3 Kbps. Default:
6.3kpbs.
When G.723 is negotiated, the selected Bit Rate will be applied only when sending the RTP packets. When
receiving RTP packets from the remote end, both the Bit Rates of G.723 will be accepted.
• Enable Silence Suppression flag, if you want SETU VFXTH to suppress the Silence packets and allow
only the Voice packets to pass through. Default: Disabled.
Silence Suppression is applicable only when you have selected G.729 as Preferred Vocoder.
• Select the Comfort Noise (CN) check box, if you want SETU VFXTH to negotiate the Comfort Noise
received in the SDP body with the remote peer. Default: Disabled.
• Select the Send VAD check box, if you want SETU VFXTH to send VAD = no in the SDP for any offer and
answer. Default: Disabled.
SETU VFXTH will send VAD = no only if G.711 ( Law) or G.711 (A - Law) codec is present in the SDP
offer or answer.
• Select the Send ptime header check box, if you want SETU VFXTH to add ptime header in the SDP offer
and answer. Default: Disabled.
• You must select the ptime value, if you have enabled Send ptime header check box and have selected
codec as—G. 729 and/or G.711 ( Law) and/or G.711 (A - Law). You can select from the following:
• 10 msec
• 20 msec
• 30 msec
• 40 msec
Default: 20 msec
For Passthrough FAX, SETU VFXTH will use the default ptime value (20 msec) only.

Matrix SETU VFXTH Specifications

General

Brand	Matrix
Model	SETU VFXTH
Category	Gateway
Language	English