26
11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
5. Check to make sure mounting plates are
square and perpendicular to the extension
plate by measuring dimensions A and B as
shown in FIG. 26-1. Squareness is acceptable
when dimensions A and B are within 1/8” of
each other.
6. Weld RH mounting plate onto vehicle body
(FIG. 26-1), then weld LH mounting plate onto
vehicle body.
STEP 3 - POSITION LIFTGATE - Continued
NOTE: Before welding mounting plates to vehicle body, check squareness to make
sure mounting plates are perpendicular to extension plate.
METHOD 1 - PRE-INSTALL MOUNTING PLATES
AND EXTENSION PLATE ON VEHICLE - Continued
GO TO STEP 4: BOLT LIFTGATE TO VEHICLE
REAR OF VEHICLE BODY
FIG. 26-1
A
B
1/4”
2-10”
1/4”
1/4” 2-10”
EXTENSION PLATE
RH MOUNTING
PLATE
LH MOUNTING
PLATE
VEHICLE
BODY
FLUSH WITH
EXTENSION
PLATE
FLUSH WITH
EXTENSION
PLATE
1/4”
WELD CORNER
POST & MOUNT-
ING PLATE WHERE
THEY MEET
2” 2”
WELD BOTH ENDS
1/4”
1/4”
2-5
2-5
WELD CORNER
POST & MOUNT-
ING PLATE WHERE
THEY MEET
To Next Page
Loading...
