EasyManua.ls Logo

Maxon BMR Series - Step 17: Check Clearance of Connector Bar Side Brackets & Stop Blocks

Maxon BMR Series
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
81
11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
2. As platform is unfolding, check for
interference from the connector
bar side bracket as it slides into
the stop block (FIG. 81-1A).
FIG. 81-1
APPROX. 10”
REAR VIEW OF LH RUNNER
FIG. 81-1A
CONNECTOR BAR SIDE
BRACKET
STOP
BLOCK
INTERFERENCE
1. To check for interference
between platform connector
bar side bracket and stop block
(FIG. 81-1A), lower columns to
approximately 10” above the
ground, then begin to unfold
platform (FIG. 81-1).
STEP 17 - CHECK CLEARANCE OF CONNECTOR
BAR SIDE BRACKETS & STOP BLOCKS

Table of Contents

Related product manuals