Maxon BMR Series

To Next Page

To Previous Page

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

NOTE: Perform this step only if folding

operation is not smooth or there

is interference.

3. If LH side bracket ﬁ ts too tight

against either side of stop block,

operation is not smooth, or if there

is interference (FIG. 82-1A) adjust

with spacers as shown in FIG.

82-1A.

4. To adjust stop block, make sure

platform is lowered to the ground

(FIG. 82-1). Then, loosen (4) bolts

(FIGS. 82-1A and 82-1B) and

check gap (FIG. 82-1A). Add or

remove shims (parts box) to ﬁ ll or

lessen the gap, then retighten bolts

(FIGS. 82-1A and 82-1B).

FIG. 82-1

REAR VIEW OF LH RUNNER

FIG. 82-1A

FRONT VIEW OF LH RUNNER

FIG. 82-1B

STOP

BLOCK

STOP

BLOCK

GAP

1/16” SPACER

1/32” SPACER

BOLTS

SIDE BRACKET

STEP 17 - CHECK CLEARANCE OF CONNECTOR

BAR SIDE BRACKETS & STOP BLOCKS - Continued

Maxon BMR Series - Page 82