54
11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
O-RING
RUN ELECTRIC CABLES
STEP 8 - RUN HYDRAULIC LINES & ELECTRIC CABLES
- Continued
2. Check that O-ring is in position and there
is no dirt or debris on the O-ring or in the
connector with sockets (FIG. 54-1).
CHECKING CONNECTOR O-RING
FIG. 54-1
GREEN
CONNECTOR
4. Apply a thin coating of dielectric grease
around the outer face of the connector
with pins, as shown in FIG. 54-2.
APPLYING DIELECTRIC GREASE TO CONNECTOR
FIG. 54-2
CAUTION
Do NOT apply any dielectric grease to
the pins or inside the connectors.
DIELECTRIC
GREASE
3. Slide a 2” long piece of 1” diameter heat
shrink sleeving (P/N 905189-04 in parts
box) over the connector.
To Next Page
Loading...
