Document reference MAVM600MK2MPS-QS/E QUICK START MANUAL
Edition 2 - February 2021 VM600
Mk2
machinery protection system (MPS)
2-7
MPC4
Mk2
machinery protection and condition monitoring module
OVERVIEW OF VM600
Mk2
MACHINERY PROTECTION SYSTEM (MPS) HARDWARE
For further information on the MPC4
Mk2
module firmware, see 4.1 MPC4
Mk2
module
firmware.
● ○ ● ○ ●
● ○ ● ○ ●
● ○ ● ○ ●
● ○ ● ○ ●
● ○ ● ○ ●
● ○ ● ○ ●
System
LED test / MPC4
Mk2
module identification.
Note: The VibroSight Protect software is used to test (blink)
all of a MPC4
Mk2
module’s LEDs. This can be used to verify
communications with a VM600
Mk2
MPS and/or help to
identify a MPC4
Mk2
module in a VM600 rack.
Notes
○ indicates a continuously off LED.
● indicates a continuously on LED (green ●, orange ● or red ●).
● ○ ● ○ ● indicates a quickly blinking LED (green ●, orange ● or red ●).
● ○○● ○○● indicates a slowly blinking LED (green ●, orange ● or red ●).
c
DSI = discrete signal interface.
c
For channels configured for “dual-channel processing”, the LEDs for both channels (CHn or AXn) exhibit the same behaviour.
Table 2-1: Behaviour of MPC4
Mk2
module LEDs
corresponding to module operating firmware (firmware version 640-025-003-000) (continued)
MPC4
Mk2
module LEDs
Description
DIAG/STATUS
CHn and/or
AXn
LOCK
VM600
Mk2
MPS level
Table 2-2: Behaviour of MPC4
Mk2
module LEDs
corresponding to module recovery firmware (firmware version 640-031-xxx-xxx)
MPC4
Mk2
module LEDs
Description
DIAG/STATUS
CHn and/or
AXn
LOCK
VM600
Mk2
MPS level
○○ ○
Recovery
Recovery firmware running
without proof test firmware installed
● ○○● ○○●
○○●
○○
Recovery
Recovery firmware running
with proof test firmware installed
Notes
○ indicates a continuously off LED.
● indicates a continuously on LED (green ●, orange ● or red ●).
● ○ ● ○ ● indicates a quickly blinking LED (green ●, orange ● or red ●).
● ○○● ○○● indicates a slowly blinking LED (green ●, orange ● or red ●).