EasyManuals Logo

Meggitt vibro-meter VM600 Quick Start Manual

Meggitt vibro-meter VM600
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
Document reference MAVM600MK2MPS-QS/E QUICK START MANUAL
Edition 2 - February 2021 VM600
Mk2
machinery protection system (MPS)
2-29
Connecting sensors/measurement chains to a VM600
Mk2
MPS
OVERVIEW OF VM600
Mk2
MACHINERY PROTECTION SYSTEM (MPS) HARDWARE
2.5 Connecting sensors/measurement chains to a VM600
Mk2
MPS
Sensors/measurement chains are connected to a VM600
Mk2
machinery protection system
(MPS) via IOC4
Mk2
input/output modules.
2.5.1 Interfacing to an IOC4
Mk2
module
Detailed information on the IOC4
Mk2
module’s connector pinouts (definition of terminals) are
given in Table 2-4, Table 2-5 and Table 2-6.
Each connector consists of a male connector (socket on module) and a mating female
connector (plug on wiring):
J1 (top) is a 24-pin connector used to connect inputs (analog signals) for the dynamic
channels (CH1 to CH4) and the auxiliary channels (AX1 and AX2).
J2 (middle) connector is a 36-pin connector used to connect inputs and ground reference
(digital signals) for the DSI control signals (AB, AR and TM), outputs (buffered “raw”
signals) for the dynamic channels (CH1 to CH4) and the auxiliary channels (AX1 and
AX2), outputs (digital (pulse train) signals (TTL-level)) for the auxiliary channels (AX1
and AX2), and outputs (analog signals) for the analog DC outputs.
J3 (bottom) connector is a 16-pin connector used to connect outputs (contacts) for the
common circuit fault relay (FAULT) and the user-configurable relays (RL1 to RL4).
NOTE: For further information on connecting sensors/measurement chains to an IOC4
Mk2
module, refer to section 9.2 Connecting vibration and pressure sensors in a VM600
machinery protection system (MPS) hardware manual.

Table of Contents

Other manuals for Meggitt vibro-meter VM600

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Meggitt vibro-meter VM600 and is the answer not in the manual?

Meggitt vibro-meter VM600 Specifications

General IconGeneral
BrandMeggitt
Modelvibro-meter VM600
CategoryProtection Device
LanguageEnglish