Megmeet MV600 Series - Page 85

85
torque
increase
cut-off point
torque
increase
cut-off point
P03.03)
P07.09
Motor 2 V/F
curve
setting
Motor 2 V/F
curve setting
0: User-customized V/F curve
1: Constant torque feature 1
2: Constant torque feature 2
3: Constant torque feature 3
4: Reserved
5: Decrease torque feature 1
6: Decrease torque feature 2
7: Decrease torque feature 3
8: Decrease torque feature 4
9: High starting torque feature 1
10: High starting torque feature 2
11: High starting torque feature 3
12: High starting torque feature 4
13: Reserved
14: Reserved
15: Reserved
16: Reserved
17: 2 times power curve
18: 1.7 times power curve
19: 1.2 times power curve
1 0 × √ ×
P07.10
Motor 2 V/F
frequency 3
Motor 2 V/F
frequency 3
P07.12~P03.15 0.01Hz 0.00Hz × √ ×
P07.11
Motor 2 V/F
voltage 3
Motor 2 V/F
voltage 3
P07.13~100.0% 0.1% 0.0% × √ ×
P07.12
Motor 2 V/F
frequency 2
Motor 2 V/F
frequency 2
P07.14 ~P07.10 0.01Hz 0.00Hz × √ ×
P07.13
Motor 2 V/F
voltage 2
Motor 2 V/F
voltage 2
P07.15~P07.11 0.1% 0.0% × √ ×
P07.14
Motor 2 V/F
frequency 1
Motor 2 V/F
frequency 1
0.00~P07.12 0.01Hz 0.00Hz × √ ×
P07.15
Motor 2 V/F
voltage 1
Motor 2 V/F
voltage 1
0~P07.13 0.1% 0.0% × √ ×
P07.16
Motor 2
torque
increase
Motor 2
torque
increase
0.0%~30.0% 0.1% 0.0% × √ ○
P07.17
Motor 2
torque
increase
cut-off point
Motor 2
torque
increase
cut-off point
0.0％~50.0% (corresponds to
P03.15)
0.1% 10.0% × √ ○
P07.18
Motor stable
factor
Motor stable
factor
0~255 1 10 × √ ○
P07.19
AVR
function
AVR function 0: Disabled 1 2 × √ ×