NetPerformer Hardware Installation Guide
5-10 Memotec Inc.
NOTE: The pinout above indicates the active signals that are used when communicating
with external DTE or DCE equipment via a NetPerformer serial interface. These
HD-26 cables are custom and proprietary to the NetPerformer. The information
in this table is not sufficient to manufacture a working cable that can interoperate
with the serial port on the NetPerformer unit.
RTSA445105CRTS4RTSA4RTSA7n/a n/a DTE Ready To Send
RTSB 19 19 13 n/a n/a n/a n/a RTSB 19 RTSB 25 n/a n/a DTE
CTSA554106DCTS5CTSA5CTSA9n/a n/a DCE Clear To Send
CTSB 13 13 19 n/a n/a n/a n/a CTSB 13 CTSB 27 n/a n/a DCE
DCDA 8 8 8 109 F DCD 8 DCDA 8 DCDA 13 I[A] 5 DCE Data Carrier
Detect (Indi-
cation on wire)DCDB 10 10 10 n/a n/a n/a n/a DCDB 10 DCDB 31 I[B] 12 DCE
n/a n/a n/a n/a 140 N RL 21 n/a n/a RL 14 n/a n/a DTE Remote
Loopback
n/a n/a n/a n/a 141 L LL 18 n/a n/a LL 10 n/a n/a DTE Local Loopback
n/a n/a n/a n/a 142 NN TI 25 n/a n/a TI 18 n/a n/a DCE Test Indicator
n/a n/a n/a n/a 125 n/s CI 22 n/a n/a CI 15 n/a n/a DCE Call Indicator
SGND 7 7 7 102 B SGND 7 SGND 7 SGND 19 SGND 8 n/a Signal Ground
n/a n/a n/a n/a 102a n/s n/a n/a n/a n/a SGND 37 n/a n/a n/a DTE Common
Return
n/a n/a n/a n/a 102b n/s n/a n/a n/a n/a SGND 20 n/a n/a n/a DCE Common
Return
SHIEL
D
1 1 1 Shield A Shield 1 Shield 1 Shield 1 Shield 1 n/a Shield
Main Board Cable V.35
TIA-232/
V.24
TIA-530
TIA-449/
V.36
X.21
Interface
Table 5-1 Serial Connector and NetPerformer Custom HD-26 Cable Set
To Next Page
Loading...
Need help?
General
