NetPerformer Hardware Installation Guide
4-10 Memotec Inc.
4.5 Optional Hardware
NOTE: The third interface card slot is not available on the SDM-9120/9220.
The fourth interface card slot is not available on the SDM-9120/9220/9230.
The Ethernet Switch is only available on the SDM-9140e.
On the NetPerformer console, the ports are identified as follows:
Item Details
DSP module: low or high-density “DSP Resources” on page 4-21
Interface cards: FXS (dual or quad port), FXO (dual
or quad port), E&M/PTT (quad port), T1/E1 (single
or dual port), Serial (dual port, SDM-9220/9230 only
or single port SDM-9120/9140 only)
“Interface Cards” on page 4-24
Table 4-4 Optional Hardware
Physical Port
Port Number on Console
(LINK)
Slot 1, digital port 1 100
Slot 1, digital port 2 150
Slot 2, digital port 1 200
Slot 2, digital port 2 250
Slot 3, digital port 1 300
Slot 3, digital port 2 350
Slot 4, digital port 1 400
Slot 4, digital port 2 450
ETHERNET (top) ETH1
ETHERNET (bottom) ETH2
ETHERNET SWITCH
(Ethernet ports 3 to 8 for
the SDM-9140e)
ETHSWITCH
SERIAL PORT 1
CONSOLE CSL
Table 4-5 List of Physical Ports and Their Port Numbers
To Next Page
Loading...
Need help?
General
