EasyManuals Logo

Memotec NetPerformer SDM-9140 User Manual

Default Icon
161 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
NetPerformer Hardware Installation Guide
1-4 Memotec Inc.
One serial port equipped with HD-26 female connector.
Two 10/100Base-T Ethernet ports (RJ45 connectors).
One console port (DB9M).
Two expansion slots.
All UAC base units come equipped with universal AC power supply and a choice
of 120 VAC North American or 240 VAC European power cord (must be specified
at time of ordering).
A DB9F-DB9F console cable and 19-inch rackmount kit are also included in the
product package.
A custom cable (HD-26 male connector) is required for the serial port, available
from Memotec Inc. or your NetPerformer distributor.
The basic software set provides support of PowerCell Voice and Data (including legacy
user data) and IP routing over Ethernet, serial or digital ports using PPP or Frame Relay
RFC-1490. Optional software licenses can be procured for support of:
SkyPerformer satellite access
TCP Acceleration
SIP VoIP
IP header compression
Link Delay Compensation
IPv6
1.2.3 SDM-9230
The NetPerformer SDM-9230 is a standalone chassis designed for network convergence
at the branch office level. It is a high speed, low cost, flexible and powerful unit that
supports analog/digital voice and data in a multitude of application scenarios. It is ideal for
branch offices that require support for up to 12 analog or 120 digital telephony channels.
The SDM-9230 base unit has a 2U chassis with:
One serial port equipped with HD-26 female connector.
Two 10/100Base-T Ethernet ports (RJ45 connectors).
One console port (DB9M).
Three expansion slots for analog voice, digital (T1/E1) voice/data and dual serial
interface cards.
All UAC base units come equipped with universal AC power supply and a choice
of 120 VAC North American or 240 VAC European power cord (must be specified
at time of ordering).
A DB9F-DB9F console cable and 19-inch rackmount kit are also included in the
product package.
A custom cable (HD-26 male connector) is required for the serial port, available
from Memotec Inc. or your NetPerformer distributor.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Memotec NetPerformer SDM-9140 and is the answer not in the manual?

Memotec NetPerformer SDM-9140 Specifications

General IconGeneral
BrandMemotec
ModelNetPerformer SDM-9140
CategoryGateway
LanguageEnglish

Related product manuals