SEAWATER COOLING SYSTEM
SERVICE MANUAL NUMBER 22
90-860074--1 FEBRUARY 2002 Page 6A-43
Installation
1. Coat threads of fluid hose connectors with Loctite Pipe Sealant with Teflon and install
on cooler in positions noted on disassembly.
a
b
Typical Transmission Fluid Cooler Shown
a-Transmission Fluid Cooler
b-Connectors
2. Install transmission fluid cooler on intake/exhaust manifold or bracket. Secure with
clamps and fasteners. Torque manifold nuts to 32 Nm (24 lb-ft).
3. Connect transmission fluid hoses to cooler in positions noted on disassembly. Tighten
hose clamps securely.
f
d
d
e
c
f
b
b
a
73522
Typical Transmission Fluid Cooler Installation Shown
a-Fluid Cooler
b-Seawater Hoses
c-Fluid Hoses
d-Retaining Clamps
e-Hex Nut and Washer
f-Connectors
To Next Page
Loading...
