SEAWATER COOLING SYSTEM SERVICE MANUAL NUMBER 22
Page 6A-44 90-860074--1 FEBRUARY 2002
4. Open seacock if equipped, or unplug seawater inlet hose and reconnect. Tighten hose
clamps securely.
5. Start engine. Operate briefly to fill cooler.
6. Check for leaks.
7. Stop engine.
IMPORTANT: Use only ATF (Automatic Transmission Fluid), such as Dexron III.
8. Quickly check transmission fluid level. Fluid should be between MIN and MAX marks
on dipstick.
9. Fill transmission to proper level.
To Next Page
Loading...
