AC1200 Wireless Dual Band Gigabit Router
the default MTU Size unless required by your ISP.
• WAN Rate Settings - Select the rate(10Mbps/100Mbps) and duplex mode(Full Duplex/Half
Duplex) for the WAN port. It is recommended to keep the default auto mode.
• Service Name/Server Name - The service name and server name should not be
configured unless it is necessary for your ISP. In most cases, leaving these fields blank will
work.
• ISP Specified IP Address - If your ISP does not automatically assign IP addresses to the
router during login, please select Use ISP Specified IP Address and enter the IP address
provided by your ISP in dotted-decimal notation.
• Primary DNS/Secondary DNS - If your ISP does not automatically assign DNS addresses
to the router during login, please select Manually Set DNS Server and enter the IP
address in dotted-decimal notation of your ISP’s primary DNS server. If a secondary DNS
server address is available, enter it as well.
Click Save to make the settings effective.
2. Dynamic IP
Select this type if your ISP provides the DHCP service, and the router will automatically get IP
parameters from your ISP.
- 18 -
To Next Page
Loading...
