MC³ 24.96.EX O&M Manual Page 71 08/14/01 4:34 PM/LDD
STORAGE
STORAGE ON RECEIPT FROM FACTORY
Storage Longer than 6 Months
Outside storage is NOT recommended. If at all possible, store electrical equipment in a heated
warehouse, above freezing temperatures.
The same precautions as above apply, plus the following:
Operate all electrical and electronic equipment at least once a year for a minimum of two hours,
preferably during a low humidity season. Operate all switches at least ten times and allow the
equipment to obtain normal operating temperature before turning off. Allow units to cool before
repackaging and returning to storage.
If stored in a warehouse with temperatures below freezing, the above applies, plus the following:
Storage up to 6 Months
Keep all equipment dry and well above the ground. If the equipment has been in transit for two
months or longer, replace the factory supplied desiccant (if so equipped) before placing in storage.
The use of evaporative corrosion inhibitors is recommended, but not mandatory.
STORAGE FOLLOWING USE
A. Clean all equipment and enclosures thoroughly inside and out.
B. Remove rust as necessary. Touch up painted surfaces as necessary to protect bare
metal surfaces. Protect electrical and electronic components from painting operations.
C. Place desiccant or evaporative corrosion inhibitors inside control enclosures.
D. Observe storage instructions as above for storage before use.
OPERATION AFTER STORAGE
When electrical equipment has been stored at either high humidity or low temperature, do not
apply power until the equipment has been allowed to stand at ambient conditions a minimum of 3
hours.
Remove all packing and/or protective materials. Remove all desiccants.
Refer to Installation on page 6 for proper installation and start-up procedures.
To Next Page
Loading...
Need help?
General
