12.09.05 rev 1.0
12
13. Connecting to the Power Supply
Connecting
Proceed as follows:
• Ensure that the power supply is switched off before introducing the plug to the socket.
• Allow adequate space around the trolley so that it is safe and accessible
• Apply the brakes on the swivel castors.
•
Ensure that the power cord is clear of any hazards and not being stretched.
•
Hold the plug firmly in your hand.
•
The green LED on the control panel will confirm power to the unit.
Disconnecting
Proceed as follows:
•
Ensure that the brakes on the swivel castors are still applied.
•
Hold the plug firmly, and withdraw it from the socket.
•
Place the plug in the holder on the front of the trolley.
• The above are given as general guidelines, but may vary depending on the type of plug and socket used.
Therefore it is essential that you follow the instructions given by the manufacturer of the specific type and model
of plug and socket used.
!
• Always check the power cord before every use.
•
Always hold the plug body and not the power cable to withdraw the plug.
•
Always store the plug in the plug holder.
:
• Never use the trolley if there are any signs of damage or fraying to the power cord.
•
Never use wet hands and ensure that both the plug and wall sockets are dry.
•
Never disconnect the trolley during a retherm cycle. ALWAYS sto
the cycle and turn the trolley off before
disconnecting from the power supply.
To Next Page
Loading...
