12.09.05 rev 1.0
21
22.
Programming a New Eprom and LO condition
When programming a new Eprom you may need to completely reprogram the unit to your own individual settings and to
commence you may need to reset the Eprom.
This sequence must be completed up to the end so that the sequence is memorized
If you are using the HIT system it is essential to program the correct time and date in the automatic timer settings even if you
do not require the machine to start automatically
Resetting LO And Entering The Serial No. of the Machine
FUNCTIONS GROUPS VALUES
And Default Individual Permissible
SUB GROUPS Settings Settings range
Take Note of the Serial Number from the Data Plate at the Rear of the Machine
Display 1
LO
Press Touch Pads Cycle 2, then 1 then 2 within 5 seconds
C L
Press Cycle 3 and Hold Until Display Stops at Group 78
Display 1 Display 2
78 00
Press Cycle 3 and Advance to Group 79
79
Press Cycle 3 and Advance to Group 80
80
Press Cycle 3 And Advance to Group 0
0
Press Cycle 2 And Advance to Group 1
1
Press Cycle 2 And Advance to Group 2
2
Press Cycle 2 And Advance to Group 3
3
Press Cycle 2 And Advance to Group 4
4
Press Cycle 2 And Advance to Group 9
9
Press Cycle 3 And Advance to Group 91
91
Keep Pressing Cycle 2 Until You Have Entered The First 2 Digits Of The Serial Number
91
**
Press Cycle 3 And Advance to Group 92
92
Keep Pressing Cycle 2 Until You Have Entered The Second 2 Digits Of The Serial Number
92
**
Press Cycle 3 And Advance to Group 0
0
Press the Off pad
To Next Page
Loading...
