12.09.05 rev 1.0
39
44.
Safety Parameters
Refrigerated Models Only
Security 1: (SC1)
The regeneration cycle will not start if the temperature of the cold section is above the set temperature (i.e. 10º C (50°F)
and “SC1” will be displayed on display 2 alternating with the cold side temperature. Selected time will be displayed on
display one. Cycle will start automatically when the proper set temperature is achieved
Safety 2:
The refrigeration will not work if the temperature of either chamber is higher than 45ºC (113°F).
Filter Alarm (F)
The refrigeration will not work if the filter becomes dirty and blocked
Compressor Delay
The compressor has been programmed with a 30-second start delay.
45.
Maintenance
Safety Precautions And Preparing For Maintenance
A maintenance program to maintain the trolley in optimal condition is clearly defined in four different categories.
•
Daily cleaning (refer to Daily Cleaning Procedure and Cleaning By Hand sections)
•
Periodic cleaning (refer to Daily Cleaning Procedure and Cleaning By Hand sections)
•
User maintenance (refer to Interim Maintenance section)
•
Maintenance schedule to manufacturer’s recommendations. Contact Burlodge Technical Department for
specialised training.
Checks Before Every Use
EQUIPMENT VISUAL OPERATIONAL NOTES
Power Supply Plug 9 Do not use if there are any signs of damage
Power Supply Cable 9 Do not use if there are any signs of damage
External Probe 9 9 Do not use if there are any signs of damage
Touch pad Controls 9 9 Do not use if there are any signs of damage
Cold Display light 9 9 Report any defect for immediate repair
Heated Top Plate 9 9 Report any defect for immediate repair
Plate Warmer 9 9 Report any defect for immediate repair
Door Latches 9 9 Report any defect for immediate repair
Refrigeration Unit 9 9 Report any defect for immediate repair
Tow Unit 9 9 Do not use if there are any signs of damage
Castors 9 9 Do not use if there are any signs of damage
Doors 9 9 Do not use if there are any signs of damage
Tray rail 9 9 Do not use if there are any signs of damage
The trolley operator should carry out the checks referred to in the above table.
SERVICING
All servicing must be performed by Burlodge authorised agents and must be to the manufacturer’s specification and at the
required intervals.
Some of the functions are optional and may not be available or operational on your trolley. In this case the relative functions
and touch pads are disabled.
To Next Page
Loading...
