12.09.05 rev 1.0
33
36.
Power Washing
:
Power washing is only recommended for the dolly and the transfer module and must not be carried out on the Multigen. When
it is used on the dolly and transfer module it must be carried out by a competent operator using extreme care and must be
confined to a designated area only.
• •
Maximum permitted water pressure 1.5 bar (21 PSI).
• •
Minimum permitted distance 0.5 meters (18 inches).
• •
Power washing must only be carried out in areas that have been specifically designed for this process.
• •
Dry thoroughly immediately after cleaning.
• •
The use of hard water may cause a build up and leave a white residue.
If any of the electrical components are accidentally sprayed with water, (e.g. the power supply plug) under no circumstances
should the trolley be used until it is completely dry and an authorised electrician has checked and passed it safe to use.
Burlodge, or its authorised service agents, must carry out any repairs during the period of warranty. Failure to comply with
these requirements may invalidate the warranty of the trolley.
•
37.
Cleaning By Hand
;
Use two containers: one containing water plus detergent and one containing clean warm water with an added sanitizer (hard
water should be avoided wherever possible), with separate soft lint free cloths. Each cloth should be rinsed and wrung in its
appropriate container.
Clean with a cloth using the water with the added detergent, wringing the cloth so that all the water is removed, then rinse with
the clean cloth, using clean warm water in conjunction with a sanitising agent and dry.
If there is any spillage of water into the electrical components (e.g. the power supply plug) under no circumstances should the
trolley be used until it is completely dry and an authorised electrician has checked and passed it safe to use. Burlodge, or its
authorised service agents, must carry out any repairs during the period of warranty. Failure to comply with these requirements
may invalidate the warranty of the trolley.