63
9 Communications
The instrument can communicate with the Metrel ES Manager PC software. The following
actions are supported:
• Saved results and Tree structure from Memory organizer can be downloaded and
stored to a PC or android device.
• Tree structure from Metrel ES Manager PC software can be uploaded to the
instrument.
• PV module list from Metrel ES Manager PC software can be uploaded to the
instrument.
• Custom Auto Sequences® can be uploaded to the instrument or downloaded and
stored to a PC.
There are three communication interfaces available on the instrument: RS232, USB and
Bluetooth.
Instrument can also communicate to A 1785 - PV Remote WL. Only Wi-Fi communication is
supported between the instrument and PV Remote WL.
9.1
The instrument automatically selects the communication mode according to detected
interface. USB interface has priority.
How to establish an USB or RS-232 link:
• RS-232 communication: connect a PC COM port to the instrument RS232 connector
using the RS232 serial communication cable.
• USB communication: connect a PC USB port to the instrument USB connector using
the USB interface cable.
• Switch on the PC and the instrument.
• Run the Metrel ES Manager software.
• Select communication port (COM port for USB communication is identified as
• The instrument is prepared to communicate with the PC.
9.2
Instrument communicates to A 1785 PV remote WL using Wi-Fi communication. To
establish Wi-Fi communication with PV Remote WL make sure that Wi-Fi communication
port is enabled on PV Remote WL. Refer to A 1785 PV Remote WL Instruction manual for
detailed information.
Before start logging environmental data perform Date & time synchronization between
devices as follows:
To Next Page
Loading...
