3.1 Setting up the instrument
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
16
￭￭￭￭￭￭￭￭
858 Professional Sample Processor
3 Installation
3.1 Setting up the instrument
3.1.1 Packaging
The instrument is supplied in protective packaging together with the sepa-
rately packed accessories. Keep this packaging, as only this ensures safe
transportation of the instrument.
3.1.2 Checks
Immediately after receipt, check whether the shipment has arrived com-
plete and without damage by comparing it with the delivery note.
3.1.3 Location
The instrument has been developed for operation indoors and may not be
used in explosive environments.
Place the instrument in a location of the laboratory which is suitable for
operation and free of vibrations and which provides protection against
corrosive atmosphere and contamination by chemicals.
The instrument should be protected against excessive temperature fluctua-
tions and direct sunlight.
3.2 Connecting the Swing Head
Take care to ensure that the Swing Head is connected before the instru-
ment is set to work. Check the connection cable.
The connection socket (Mini DIN) for the Swing Head drive is located on
the rear of the tower next to the stirrer connector.
Figure 10
Connecting the Swing Head
To Next Page
Loading...
Need help?
General
