EasyManuals Logo

Metrohm 858 User Manual

Metrohm 858
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
■■■■■■■■■■■■■■■■■■■■■■
3 Installation
858 Professional Sample Processor
■■■■■■■■
33
this, you must comply with the procedures specified. The following steps
are necessary:
1
Install the software
Insert the computer software installation CD and carry out the
installation program directions.
Exit the program if you have started it after the installation.
2
Establishing the cable connections
Connect the instrument to the power grid if you have not already
done this (see chapter 3.3, page 17).
Connect the instrument to a USB connector (type A) of your com-
puter (see manual of your computer). The 6.2151.000 cable is
used for this purpose.
6.2151.000
USB 2
USB 1
Contr.
MSB 2
Figure 31 Connecting the computer
The instrument is recognized. Depending on the version of the Win-
dows operating system used, the driver installation proceeds differ-
ently afterwards. Either the necessary driver software is installed
automatically or an installation wizard is started.
3
Follow the instructions of the installation wizard.
If problems should occur during installation, contact your company's IT
support team.
NOTICE
The plug on the instrument end of the 6.2151.000 controller cable is
protected against accidental disconnection by means of a pull-out pro-
tection feature. If you wish to pull out the plug, you first need to pull
back the outer plug sleeve marked with arrows.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Metrohm 858 and is the answer not in the manual?

Metrohm 858 Specifications

General IconGeneral
BrandMetrohm
Model858
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals