Metrohm 858 - Figure 18 Mounting the Stirrer and the Dilution Vessel; Figure 19 Mounting the Cross Strut

3.6 Mounting the stand plate
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
22
￭￭￭￭￭￭￭￭
858 Professional Sample Processor
Figure 18 Mounting the stirrer and the dilution vessel
4
Mounting the cross strut
￭ Assemble the cross strut according to the drawing shown below.
￭ Fasten the cross strut provisionally to the support rod.
Figure 19 Mounting the cross strut
5
Fixing the support rod
￭ Screw the cross strut to the rear of the tower with the hex screw
provided as shown below.
￭ Tighten all hex screws.