￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
858 Professional Sample Processor
￭￭￭￭￭￭￭￭
III
Table of contents
1 Introduction 1
1.1 Area of application ............................................................... 1
1.2 Instrument description ......................................................... 1
1.3 Model versions ...................................................................... 2
1.4 Intended use ......................................................................... 3
1.5 About the documentation ................................................... 3
1.5.1 Symbols and conventions ........................................................ 3
1.6 Safety instructions ................................................................ 4
1.6.1 General notes on safety ........................................................... 4
1.6.2 Electrical safety ........................................................................ 4
1.6.3 Personnel safety ....................................................................... 5
1.7 Recycling and disposal ......................................................... 7
2 Overview of the instrument 8
2.1 Front ...................................................................................... 8
2.2 Rear ........................................................................................ 9
2.3 Connector strip ................................................................... 10
2.4 Sample racks ....................................................................... 10
2.5 The Swing Head .................................................................. 12
2.6 Peristaltic pump .................................................................. 14
2.7 Injection valve ..................................................................... 15
3 Installation 16
3.1 Setting up the instrument .................................................. 16
3.1.1 Packaging .............................................................................. 16
3.1.2 Checks .................................................................................. 16
3.1.3 Location ................................................................................ 16
3.2 Connecting the Swing Head .............................................. 16
3.3 Connecting the instrument to the power grid ................. 17
3.4 Mounting the retaining plate ............................................ 18
3.5 Mounting a filtration cell holder or Dosino holder ......... 18
3.6 Mounting the stand plate .................................................. 20
3.7 Placing tubing and cables in the guide chain .................. 23
3.8 Installing the sample needle .............................................. 24
3.9 Mounting the safety shield ................................................ 26
To Next Page
Loading...
Need help?
General
