3.1 Switching the instrument on and off
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
26
￭￭￭￭￭￭￭￭
NOTICE
If a buret unit is connected, then a request appears to carry out
the Prepare function:
All tubings and the cylinder are rinsed with the Prepare function.
The preparing of the buret unit is described in the Preparing buret
unit section later in the document.
￭ Confirm the message with [OK].
The main dialog is displayed:
Switching off the instrument
CAUTION
The 917 Coulometer must be switched off by pressing the power
switch on the rear of the instrument before the electricity supply is
interrupted. If this is not done, then there is a danger of data loss.
To Next Page
Loading...
Need help?
General
