8.2 Automatic login with USB flash drive
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
54
￭￭￭￭￭￭￭￭
If you would like to work without a login, it is sufficient to create a
user list. Each user can select his or her entry from the user list in the
main dialog. Then the user name will be printed out with reports
and/or saved along with a determination.
8.2 Automatic login with USB flash drive
It is possible to have automatic user recognition without requiring that a
password be entered. If each user uses a USB flash drive of his or her own
with his or her user profile, then the instrument can recognize whose USB
flash drive it is at the time of the switching on. User login then takes place
automatically.
The USB flash drive can be used for saving determination data, methods,
PC/LIMS reports or for backing up the entire system.
Creating user profiles
You now need to create an ID profile for each user on a separate USB
flash drive. The USB flash drive must be formatted.
Proceed as follows:
1
Plugging in the USB flash drive
￭ Return to the main dialog with [ ].
￭ Plug in a USB flash drive into the rear of the 917 Coulometer.
￭ Wait until a message appears which confirms that the USB flash
drive has been recognized.
2
Saving the user profile
￭ Switch over to the user administration with [System], [System
settings] and [User admin.].
￭ Select a user name.
￭ Tap on [Create ID profile].
A message will appear which confirms the creation of the ID profile.
If you now set the login options, you will automatically be logged in
at once with this ID profile.
To Next Page
Loading...
Need help?
General
