CDP301 Dew-Point Tester User’s Manual
Michell Instruments vii
Safety
This manual contains all the required information to install, operate and maintain this product. It
should be read and understood prior to use. Installation and operation of this product should be
carried out by suitably competent personnel only and must be in accordance with the terms of this
manual and associated safety certificates. Incorrect installation and operation of this product for
other than its intended purpose will render all warranties void.
This product is intended for use in a Hazardous Area and is awarded an ATEX, IECEx and cQPSus
Certificate. The relevant certificates should be fully examined and understood prior to installation or
use of this product.
Electrical Safety
The instrument is designed to be completely safe when used with options and accessories supplied
by the manufacturer for use with the instrument.
Pressure Safety
DO NOT permit pressures greater than the safe working pressure to be applied to the instrument.
The specified safe working pressure is 100 barg (1450 psig). Refer to the Technical Specifications in
Appendix A.
Toxic Materials
The use of hazardous materials in the construction of this instrument has been minimized. During
normal operation it is not possible for the user to come into contact with any hazardous substance
which might be employed in the construction of the instrument. Care should, however, be exercised
during maintenance and the disposal of certain parts.
Repair and Maintenance
The instrument must be maintained either by the manufacturer or an accredited service agent. For
Michell Instruments’ contact information please go to www.michell.com.
Safety Conformity
This product meets the essential protection requirements of the relevant EU and US standards
and directives. Further details of applied standards may be found in the Technical Specifications in
Appendix A.
To Next Page
Loading...
Need help?
General