Installation, Programming and Maintenance Microdos Pooltec
Rev. 1.0 EN
4
WARNINGS
Please read carefully the instructions given below, as they supply you with all the needed information, necessary for
installation, use and maintenance.
Once you receive the MICRODOS POOLTEC check out for its integrity and all its components, in case of any anomalies, please consult
a skilled staff before making any operation. The equipment must be operated by skilled persons.
For a correct functioning it is necessary to use original spare parts and original accessories. Microdos declines whatever responsibility
in reference to break down due to tampering or the use of not original spare parts and accessories.
The electrical plant must be in conformity with the rules of the country where it is realised.
During maintenance and repair of parts in contact with chemicals, always use personal protection measures (gloves, aprons, goggles,
etc.).
The usage room temperature cannot overtake 45 °C. The minimum temperature depends on the chemical that must remain in the
liquid state.
Microdos declines all responsibility in reference to any intervention on the equipment from a non-skilled staff.
HAZARDS
Ignoring the instructions can result in equipment damage and, in extreme cases, injury to persons.
Before installing the equipment make sure that the electrical data reported on the label correspond to those of your electrical
plant.
All maintenance or repair must be performed with the system electrically isolated.
Whenever you need to access the connection box, turn off MICRODOS POOLTEC and isolate it electrically.
Do not operate on the equipment with wet hands or feet.
Do not leave the equipment exposed to the action of atmospheric agents.
In case of an improper functioning of the equipment switch off and contact our technical assistance for any reparation request.
WARNING: PROPER AND IMPROPER USE
The instrument MICRODOS POOLTEC should be used only for the purposes for which it was designed that is, the measurement
and control of the values of the chemical and physical parameters.
Uses other than these are considered improper and therefore dangerous.
The instrument is NOT designed for use in environment with danger of explosion.
Microdos declines any responsibility for any damage resulting from the improper and / or unreasonable use of the instrument.
WARRANTY CERTIFICATE
The controllers manufactured by Microdos are warranted to be free from defects in workmanship and material for 24months of
operation starting from the delivery date to the first purchaser.
Within the above stated period Microdos will supply free of charge any part that upon examination by Microdos or by an authorised
dealer, is disclosed to have been defective in workmanship or material, or at its option, it will repair the parts directly or through
authorized workshops. It remains anyway excluded from whatever responsibility and obligation for other costs, damages and direct or
indirect losses that come from the use or the not use availability, either total or partial. They remain anyway at charge of the purchaser
the costs of plan controllers mounting and disassembling, transport cost and using materials. Producer’s’ duties, as above are not
valid when:
The controllers are not used according to Microdos’s instructions as in the operating manual and maintenance instructions.
The controllers are repaired, disassembled, modified by workshops not authorized from Microdos.
They have used not original spare parts.
The electronic plans have been damaged because of external causes such as whatever type of over tensions.
At the end of the 24 months from the delivery date, Microdos will be free from any liability and from all the duties as above. This
guarantee, that starts from the 1st of January 2006, nullifies and substitutes whatever guarantee, expressed or implicit, and cannot
be modified but in writing.
Design standard
Built accordingly to the current general standards endowed with CE mark in conformity with the following European directives:
• 2014/30/CE regarding “electromagnetic compatibilities”.
• 2014/35/CE regarding “low voltages”,
• 2014/53/EU “RED Radio Equipment Directive”
TECHNICAL DATA
-
Maximum ambient temperature: 45°C
- IP: 55
- Material: ABS
- Electrical data: see type plate on the unit.
Frequency and transmission power data referred to the pump with wi-fi circuit:
- Transmission frequency: DFS transmission protocol on 2.4GHz and 5GHz
- Power: 20dB
To Next Page
Loading...