Installation, Programming and Maintenance Microdos Pooltec
Rev. 1.0 EN
5
1. IMPORTANT SAFETY INSTRUCTIONS
1.1. ELECTRICAL SPECIFICATIONS AND FEATURES
ELECTRICAL SPECIFICATIONS:
Power supply 110÷230 VAC
Operating frequency 50 Hz
Energy consumption when not running 120 mA.
Operating temperature + 5° / + 55°C
Maximum operating humidity 95% with no condensation
Protection of the environment IP55
OPERATING ALGORITHMS:
Manual/ automatic operation? Yes
User programs? Yes
Temperature display At 0°/55°C intervals; accurate to +/- 0.1ºC
pH display At 0/14 pH intervals
ORP display At intervals of 0/1000 mV.
Automatic pH dose corrector By peristaltic/solenoid pump
Automatic Rx dosing By peristaltic/solenoid pump
Touch-screen Colour 10"
Programming By touchscreen and passwords (expert and installer)
Type of programming User-friendly and intuitive
WARNINGS FOR GENERAL OPERATION OF MICRODOS POOLTEC
1. VERIFY PROGRAMMING AFTER UPTDATING THE DEVICE: TIME PROGRAMMING, PH AND RX SET POINTS, HEATING, ETC...
2. ACCESS CODE – For menus and special functions:
The installer password can be changed (see page 40)
ATTENTION: the device is designed to stay on 24 hours a day, avoiding frequent shutdown cycles.
PLEASE READ AND FOLLOW THESE INSTRUCTIONS
It is essential when installing a control and disinfection system at a pool to take certain precautions
while handling equipment, also more generally when using the pool.
DANGER: Low-voltage electricity risk: Do not open or touch the control unit: there is a risk of electric shock.
Contact your local retailer or the manufacturer.
Follow the electricity safety instructions specified by your company, also local or national regulations.
DANGER: Risk of accidents or drowning: Use of the pool calls for special care. Observe the safety and
hygiene instructions laid down. These are displayed near the pool, or in accordance with local or national
regulations.
To Next Page
Loading...