migra Ethernet/IP
Large Format, Graphics Compatible Display with Ethernet/IP Interface
Page 55
microSYST Systemelectronic GmbH, Am Gewerbepark 11, 92670 Windischeschenbach
+49 9681 91960-0, +49 9681 91960-10, info@microsyst.de, www.microsyst.de
5.2 Maintenance and Care
Observe the following instructions in order to assure best possible
performance of the display:
Make sure that the housing can be opened for adjustment and
maintenance even after the display has been installed. Allow for
adequate clearance at the back, front and top of the display unit in
order to assure sufficient ventilation (if vent slots are included).
Display quality is impaired by direct illumination with bright light
sources and/or direct sunlight.
The display must be switched off before cleaning.
Protect the display from excessive humidity, extreme vibration,
direct sunlight and extreme temperatures. Non-observance may
lead to malfunctioning or destruction of the device. Under certain
circumstances electrical shock, fire and explosion may occur as
well. Information concerning allowable ambient conditions, in
particular recommended temperature ranges, can be found in the
chapter entitled “Technical Data”.
The display may not be placed into service if the device and/or the
power cable are known to be damaged.
Do not attempt to repair the device yourself. The guarantee is
rendered null and void if the device is tampered with by
unauthorised persons.
Observe all notes and instructions included in this user’s manual.
To Next Page
Loading...
Need help?
General
