Microtek ScanWizard EZ - Professional Mode Reference Manual 9
Unit of Measurement/Rulers
The rulers on both sides of the Overview window assist you in measurement or
in checking the alignment of your image.
The unit of measurement in the ruler can be selected in two ways: in the Image
Dimension controls located in the Settings window, or by clicking the ruler unit
button at the 0,0 point of the rulers in the Overview window.
Depending on your selection, the rulers can mark off measurement in these
units: inch, centimeter, millimeter, point, pixel, and pica. The pixel option is
dimmed if the selected resolution unit is lpi, and vice versa.
To select the unit of measurement for the rulers:
Click the unit box in the Settings window, or click the ruler unit button (
) at
the 0,0 point of the rulers in the Overview window. When the submenu appears,
select the unit of measurement.
To Next Page
Loading...
Need help?
General
