28
(2) Please use [↑] or [↓] to select the item needed.
(3) If needed, please press S1 (PROG) or ←→ [Item selection] to switch.
(4) Press [Exit] to exit when completed.
(1) TESTER ID
Allows assigning an ID for this tester.
(2) TEST ALARM
This function provides alarms for test results; there are a total of 4 options that can be set according
to the needs.
ALL There is sound whether the result of the DUT is good or failed.
NO There is no sound whether the result of the DUT is good or failed.
PASS There is only sound when the result of the DUT is good.
FAIL There is only sound when the result of the DUT failed.
(3) CONSECUTIVE ALARM
When errors occur during testing, a continuous alarm will sound.
ON: Enables the consecutive alarm function.
OFF: Disables the consecutive alarm function.
(4) DISPLAY TEST DATA
This function is used to set the display of the test statistical data and print format; there are a total of
three options.
ALL Display and print test data whether there are errors or not.
NO Do not display and print test data whether there are errors or not.
FAIL Display and print error step.
(5) AUTO PRINT DATA
Whether to print test data automatically. There is a total of two options and the default value is |Key|.
KEY: Auto print data mode is off and keys are used to control whether to print the test data.
AUTO: Auto print data mode is on.
(6) OUTPUT SIGNAL
Selects signal output mode. There are three modes: STATIC, PULSE, and ON.
OFF: Remote control with no output.
To Next Page
Loading...
