Midmark VetPro - Page 105

VetPro DC Installation/Service Manual, 00-02-1606, Revision R01
102
Figure 87
15. Break loose the spanner ring by turning the spanner wrench counter
clockwise.
16. Repeat steps 14 & 15 to remove the second spanner ring.
Figure 88
17. Carefully remove the tubehead from the yoke.
Figure 89
18. Remember to transfer the friction ring from the original tubehead to the
new tubehead. The friction ring will either be on the shaft of the original
tubehead or in the yoke assembly
Friction Ring