Technical Information
G1000 / G2000 Dishwashers
6.1.1 Water Hardness Setting – Checking and Programming
Access the programming mode.
The display shows P and the set value alternately. Setting range: P0 to P70 =
Water hardness.
E.g. P15 (standard setting) corresponds to 15 gr/gal, (15°d),
see Table 6-2.
Water hardness
(°d, degree of German hardness)
Grains per Gallon
Gr/gal
Display
Sensor softener active (on certain models)
-- P0
Without softener
1°d 1 P1
2°d 2 P2
3°d 3 P3
*** *** ***
*** *** ***
36°d 36 P36
37 - 50°d 37 – 50 P50
51 - 60°d 51 – 60 P60
61 - 70°d 61 - 70 P70
Table 6-2: Water Hardness: Standard setting: 15 gr/gal (15 °d)
6.2 Advanta Series
6.2.1 Advanta Series - G2020
6.2.1.1 G2020 - Programming Mode
Accessing
1. Press and hold the Start/Stop button.
2. Switch on the machine.
3. Release the Start/Stop button.
4. Immediately press and release the Start/Stop button 5 times and at the 5th
time hold until the Start/Stop LED flashes rapidly.
5. Release the Start/Stop button
If the Start/Stop LED does not flash, repeat the procedure.
107
To Next Page
Loading...
