Technical Information
G1000 / G2000 Dishwashers
6.7 Fault Code Summary
Important
Not all fault codes apply to all model numbers
Faulty Code Summary
F00 No faults
F01 Water/Heating NTC temperature sensor or leads short-circuited
F02 Water/Heating NTC temperature sensor or leads open-circuited
F11 Drainage fault
F12 Water intake fault at start of step
F13 Water intake fault at end of step
F14 Water intake fault: Heater pressure switch
F15 Water intake fault: Hot water
F18 Flow meter stationary state monitor
F19 Flow meter stiff and not turning freely
F24 Heating relay contact
F25 Desired temperature fault
F26 Boiling protection
F40 Electronic unit fault
F42 Mains frequency registration fault
F47 Interface fault (BAE) and (SLT)
F51 Heater pressure switch
F52 Heater pressure switch has reset during heating
F53 Speed sensor fault
F63 Slide shutter fault
F67 Circulation pump speed too low
F68 Circulation pump operation after switch-off
F69 Circulation pump blocked
F70 Float switch fault
F84 Slide shutter positioning fault
F85 Slide shutter signal change fault
F86 Salt container lid contact fault
F87 Sensor softener fault
F88 Turbidity sensor fault
F91 Load size registration inactive
Table 6-58: Fault Code Summary
203
To Next Page
Loading...
