Technical Information
G1000 / G2000 Dishwashers
6.6.2 G2830 – Service Mode
Initial requirements
1. Close the door.
2. Switch off the machine.
Accessing
1. Press and hold the C (Clear) button or touchpad.
2. Switch on the machine.
3. Release the C (Clear) button or touchpad.
4. Immediately press and release the C (Clear) button or touchpad 3 times, at the
3rd time hold for at least 4 seconds.
Acknowledgement Indicator
Successful accessing of the Service mode is indicated by the LEDs, which are all off
and the indication Service program shown in the right of the display.
The display shows two parameters at the same time.
Use the cursor buttons as appropriate to scroll the display.
Options
Refer to Table: 6-57
197
To Next Page
Loading...
