Technical Information
G1000 / G2000 Dishwashers
6.4 Optima Series
6.4.1 Optima Series – G2420 & G2430
6.4.1.1 G2420 / G2430 – Programming Mode
Initial requirements
1. Close the door.
2. Switch off the machine.
Accessing
1. Press and hold the Start/Stop button.
2. Switch on the machine.
3. Release the Start/Stop button.
4. Wait for dot in display, then immediately press and release the Start/Stop
button 5 times and on the 5th time hold until the Start/Stop LED flashes rapidly.
5. Release the Start/Stop button
If the Start/Stop LED does not flash, repeat the procedure.
Acknowledgement Indicator
Successful accessing of the Service Dept. programming mode is indicated by a rapid
flashing Start/Stop LED (5 Hz)
Options
Refer to Tables: 6-31 through 6-35.
151
To Next Page
Loading...
