Miele G2000 - Page 147

Technical Information
G1000 / G2000 Dishwashers
Flashing rhythm
of Intake/Drain
LED
Function Programming Indication
Flashing rhythm of
SaniWash LED
Long Short Long Short
- -
Pos. 0:
Software
version
ID check
Do not press the
Program button. The
Intake/Drain LED is off.
T
he Sani-Wash LED is off or
f
lashes. Shows the software
v
ersion ID No., e.g. -769
- - ID No.
- - F0
- 1 F1
- 2 F2
1 1 F11
1 2 F12
1 3 F13
1 4 F14
1 8 F18
1 9 F19
Press the Program
button 1x.
If the fault is indicated in
the SaniWash LED,
check if additional faults
are registered. Press the
Program button and hold
it until the Intake/Drain
LED flashes. Then press
the Program button
briefly. *1
T
he Intake/Drain LED flashes 1x.
2 4 F24
- 1
Pos. 1:
Fault
memory
display
and
deletion
If faults are saved into memory,
t
hese are indicated via the flashing
r
hythm of the SaniWash LED.
Refer to 6.7 Fault code summary.
2 5 F25
2 6 F26
4 - F40
5 1 F51
5 2 F52
6 9 F69
7 - F70
To delete the fault
memory, press the
Program button and hold
until the Intake/Drain
LED flashes. Then press
the Program button until
the SaniWash LED goes
out.
T
he SaniWash LED is off = F0 (no
f
aults).
8 8 F88
Press the Program
button 2x.
T
he Intake/Drain LED flashes 2x.
- - U0
- 1 U1
- 2 U2
- 3 U3
- 4 U4
- 5 U5
- 6 U6
- 7 U7
- 8 U8
- 9 U9
1 0 U10
1 1 U11
1 2 U12
1 3 U13
- 2
Pos.2:
Compon
ent test
To start the component
test, press the Program
button and hold until the
Intake/Drain LED
flashes. Then press the
Program button briefly.
Press the Program
button again to access
each of the following
components. *1
T
he flashing rhythm of the
S
aniWash LED indicates which
c
omponent is currently accessed.
For the sequence of component
t
esting as well as backgraound
i
nformation and access
p
rocedures, refer to 6.3.2.3
C
omponent test.
1 4 U14
Table 6-29: G1180 / G2180 Service Mode (Continued on Table 6-30)
147